Ultra Start Automobile Alarm 441 Series User Manual

OWNER’S GUIDE  
Covers All 430, 440, 441 and CJ Series  
Advanced Security Systems  
FCC/ID Notice  
This device complies with Part 15 of the FCC rules. Operation is subject to the following conditions:  
(1) This device may not cause harmful interference, and  
(2) This device must accept any interference received, including interference that may cause  
undesired operation.  
CAUTION: Changes or modifications not expressly approved by the part responsible for compliance  
void the user’s authority to operate this devise.  
 
REMOTE VEHICLE SECURITY  
OWNER’S MANUAL  
PAGE 3  
Alarm Functions  
Arm  
1. Press and release the button.  
2. The park lights will flash and the siren will chirp one time.  
3. The doors will lock (optional).  
NOTE: The LED will start flashing within five seconds. If installed, the starter  
disable will activate.  
Disarm  
1.Press and release the button on the remote transmitter.  
2.The park lights will flash and the siren will chirp two times.  
3.The doors will unlock (optional).  
NOTE: The LED will stop flashing. If installed, the starter disable will deactivate.  
Silent Arm/Disarm  
1. Press and release the button then press and release the button to  
silent arm. The park lights will flash once to confirm.  
2. Press and release the button then press and release the button to  
silent disarm. The park lights will flash twice to confirm.  
Panic  
1. Press and hold the button on the remote transmitter.  
2. The park lights will flash and the siren will sound.  
3. Press and release the or the button to deactivate*.  
*Panic will be active for 60 seconds or until disabled by the remote transmitter.  
Trunk  
1. Press and hold the button for 3 seconds.  
2. The doors will unlock (optional), continue holding until the Trunk Release  
activates.  
Car Finder  
1. Press and hold the button for 3 seconds.  
2. The park lights will flash and the siren will chirp 5 times.  
 
OWNER’S MANUAL  
PAGE 4  
REMOTE VEHICLE SECURITY  
Service Mode  
1. The system must be disarmed and the ignition is turned OFF.  
2.Press and release the lock and unlock buttons at the same time, then press  
and hold the lock button for five seconds.  
3.The system will respond with five chirps and park light flashes to confirm  
that the system is in Valet mode.  
4. The LED will stay ON steady to confirm Valet Mode.  
Exit Service Mode  
1.Press and release the lock and unlock buttons at the same time, then press  
and hold the lock button for five seconds.  
2.The system will respond with two chirps and park light flashes to confirm that  
the system has exited Valet mode.  
3. The LED will turn OFF.  
Note: If the LED does not turn off, check that all the door’s are closed. The LED  
stays On solid when a door is left opened.  
Emergency Service Mode  
Emergency Service Mode temporarily disables the alarm system. This feature  
can be used if the remote is lost or if the system malfunctions.  
ENTERING VALET MODE  
1.While the ignition is “On” press and hold the Service button for five seconds.  
The siren will chirps five times.  
2.Alarm functions will be disabled and the LED will be ON steady. The door-locks  
and trunk release are still operational.  
EXITING VALET MODE  
1.While the ignition is “On”press and hold the Service button for five seconds.  
The siren will chirps two times.  
2. The system returns to normal operation.  
Starter Disable  
The system has an optional starter disable output that can be connected by your  
dealer. When the starter disable relay is installed and connected to the system,  
the vehicle’s starter will be disabled when the system is armed.  
To activate the starter disable press the lock button on the remote. The system  
will arm and the starter will no longer operate.  
To deactivate the starter disable, press the unlock button and the LEDS will stop  
DownloadflfarsohmingWanwdwth.eSsotamrtearnwuilal blse.creo-emna.bAleldl .Manuals Search And Download.  
REMOTE VEHICLE SECURITY  
OWNER’S MANUAL  
PAGE 5  
Transmitter Programming  
Follow the steps below to program the transmitters to the system s memory  
Step 1 - Turn the Ignition key ON then OFF - Leaving Key Off.  
Step 2 - Press and release the Program Button twice then press and hold.  
Step 3 - The siren will respond with five chirps to confirm Transmitter Program Mode.  
Note: If the siren does not respond, repeat Steps1&2  
Step 4 - Continue to hold the Program Button and press lock button on each of the  
transmitter’s to be programmed(Maximum of 3 Different transmitter codes).  
Step 5 - The system will respond with a siren chirp each time a transmitter is programmed.  
Exit - After five seconds the system will exit transmitter program mode automatically.  
NOTE: You must program ALL of the transmitters to be used at one time. For the owner’s  
security any transmitters not programmed at this time will be erased from memory.  
*** This system will store a maximum of three transmitter codes in memory.  
Battery Replacement  
The transmitter battery should be changed at least once every year to maintain  
proper operating range. Replace with a quality 23A 12volt Alkaline battery  
(OE remote). Replace with two quality 3V lithium batteries (XR remote).  
Test remote for  
proper operation.  
Remove the top  
case, then replace  
the battery.  
Replace top case  
and Re-install  
screw.  
Carefully remove  
the screw from the  
back of the remote.  
 
OWNER’S MANUAL  
PAGE 6  
REMOTE VEHICLE SECURITY  
Alarm Triggered  
1.When the alarm is triggered by the door, hood, shock etc., the siren will activate  
in 60 second cycles. After 60 seconds the siren will turn off and the system will  
return to the armed state.  
2. To turn off siren before 60 seconds has expired, press the lock or unlock button.  
NOTE: When the alarm is disarmed if the siren chirps three times, this indicates  
that the alarm has been set off.  
Passive Arming  
This optional feature will arm your system automatically upon leaving vehicle.  
1.Turn ignition off and then open and close door.  
2.The LED will flash rapidly indicating system will arm in 30 seconds.  
NOTE: If the door is opened during this time, the system will wait for the door  
to close again to start passive arming.  
3. After 30 seconds the system will arm. If the optional Passive Locks feature  
is programmed ”On” the doors will lock when the system arms.  
*Use caution when the Passive Locks feature is programmed “On”. Do not  
leave the keys in the ignition.  
Car Jack Mode Activation (CJ series ONLY).  
1) If the ignition key is On and a door is opened the Car Jack Mode  
Timer will start. The siren will chirp one every second for 10  
seconds then trigger into full alarm.  
2) If the timer was activated by accident, within 10 seconds turn the  
ignition key back to On then press and release the program  
button one time. The Car Jack Mode Timer will stop.  
3) If the timer is not deactivated Car Jack Mode will trigger into full  
alarm. To deactivate turn the ignition On, then press and release  
the program button 5 times then press unlock on the remote  
transmitter.  
Emergency Override.  
If Car Jack Mode is not deactivated in time, the system will need to  
be placed into Emergency Override. Turn the ignition key to the On  
position then press and hold the program button for 20seconds. At  
this time the customer can bring the vehicle back to the dealer for a  
system reset.  
 
REMOTE VEHICLE SECURITY  
OWNER’S MANUAL  
PAGE 7  
Notes  
 
OWNER’S MANUAL  
PAGE 8  
REMOTE VEHICLE SECURITY  
WARRANTY  
The manufacturer warrants to the original purchaser of their remote starters and alarms, that the product shall be free from  
defects in material and workmanship. However, should this product be proven to be defective, within a two year period from  
the original date of purchase, the manufacturer will, without charge to the purchaser (excluding any charges incurred to have  
the product delivered to the manufacturer) , repair or replace any part of the remote starter and/or alarm which the  
manufacturer agrees to be defective. All warranties apply on to the original purchaser and the vehicle in which it is originally  
installed. Repairs or replacement of defective modules shall remain at the discretion of the manufacturer. All other parts,  
components, accessories and/or optional equipment pertaining to the remote starter and alarm are not included in the  
manufacturer’s warranty. This warranty is non-transferable. Request for warranty service from any Factory Authorized  
Dealer must be accompanied with the original purchase receipt or have product registered by authorized dealer on  
manufacturer’s website. Failure to comply with any of these conditions may result in warranty being voided.  
This warranty does not cover the following: removal and reinstall labour charges, shipping charges, abuse, misuse, or  
accidental damages to the remote starter and alarm, automobile, and/or parts there of. This warranty is void upon  
modification, repairs, or alterations of any part of the System. The manufacturer does not guarantee or insure against theft of  
the vehicle or its contents. Alarm models are designed only to act as a deterrent against possible theft. This alarm may qualify  
for auto insurance discounts, contact your Insurance Agent for further information . The manufacturer shall not be held liable  
for any consequential damages due to breach of this or any other warranty, expressed, or implied. This warranty gives you  
specific legal rights. Your specific legal rights may vary for each region.  
CERTAIN DAMAGES EXCLUDED  
-
The manufacturer expressly disclaims any liability or responsibility for incidental  
damages caused by the product, including economic loss, loss of use of the product, car rentals, or any other costs relating to  
the care and custody of the product. The manufacturer disclaims liability or responsibility for any consequential damages  
caused by the product or resulting from its use, including the cost of repairing or replacing other property damaged by the  
product or caused by its use, whether or not the product is working properly. The product is intended to deter unauthorized use  
of the vehicles in which it is installed. The manufacturer does not warrant that the product is fool-safe against theft and/or  
vandalism and/or human error or misuse. The manufacturer accepts no liability or responsibility for any damage of any kind  
whatsoever caused to any vehicle in which the product is installed or any resulting damage from its use. The manufacturer  
accepts no responsibility or liability for any damage resulting to or theft of the vehicle or its contents, caused or alleged to be  
caused, directly or indirectly, by failure of the product.  
 

Thecus Technology Server N8800 User Manual
Timex Watch 791 095003 User Manual
Toastmaster Humidifier WST7503 User Manual
Toshiba DVD Player SD M1401 User Manual
Tripp Lite Network Cables N201 010 BK User Manual
Tyan Computer Computer Hardware S8236 User Manual
Uniden Copier MC 800 User Manual
Universal Electronics Universal Remote URC 2505 User Manual
Vivotek Security Camera SD8111 User Manual
Vizio Carpet Cleaner V 128 User Manual